Perform Courtesy Inspection of vehicle and list any findings
Has not been run through system Safety- Fails, RF inner tie rod end excess play, RF inner cv axle boot ripped apart, slinging grease. Both front lower control arm rear bushings separating. Emissions- Fails, check engine light on, ECU code P0420 Catalyst system efficiency below threshold, ABS code C0057 VDC control interruption because of engine instructions
Replaced RF inner tire rod end
Aligned, set rear and front toe, other measurements in spec.
Replaced RF cv axle shaft
Replaced both front lower rearward control arm bushings
Replaced both front stabilizer links
ECU code P0420 Catalyst system efficiency below threshold, ABS code C0057 VDC control interruption because of engine instructions
Morgan B. gave our service a 5 star review on 5/2/2024
We recommend replacing your cabin air filter and your air filter
Two parts of the heat shield were rattling one was hanging out and one was flapping on the exhaust I pulled one off and put two bolts and Two Nuts in the other one
Change oil and filter, Check fluids top off if needed
Dick H. gave our service a 5 star review on 12/19/2023
Perform Courtesy Inspection of vehicle and list any findings
The cel is illuminated. Left low beam is not working. The right rear strut is leaking oil. Both rear rocker panels are rusted and will need a weld repair.
Has codes P0032 b1s1 oxygen sensor heater circuit high P0030 b1s1 oxygen sensor heater performance
Charles N. gave our service a 5 star review on 10/24/2022
Further Repairs needed: -Severe fluid leak from transmission -Missing dip stick for transmission -Both front axles spraying grease -Needs front subframe rotted with holes -Rear struts leaking -Right front outer tie rod loose -Right rear strut loose -Right rear wheel bearing has play -Rear brakes rusty
-Confirmed car does not move when clutch pedal is engaged or disengaged -R&R Charge Air Cooler to gain access to slave cylinder -Slave cylinder and clutch fork are both moving correctly -All shift linkages connected and functioning properly -Will need to remove transmission for any further diag to see if it is a clutch or input shaft issue -Removed transmission to find the clutch debris coating flywheel, pressure plate, and input shaft indicating it needs a new clutch -Also noticed the input shaft housing is cracked – For proper repair parts needed are *Flywheel *Clutch *Pressure plate *Throwout bearing *Pliot bearing and input shaft -Remove transmission to access clutch
Customer states Rear Oxygen Sensor near wheel well needs to be replaced. They have the sensor on passenger seat. Identify what it will required to replace and advise service.
Lucas K. gave our service a 5 star review on 7/29/2022